Roof & Wall Insulation

Roof Insulation

An aluminum film will be placed between the roof tiles and the structure of the roof. This film shall be made of synthetic structure (not paper based) to resist high moisture environment. Its reflective face will be placed up both side and will be of pure aluminum (not metallized) for a radiation reflection higher than 95%.

Almost 100% of PEBs/Steel structures world-wide are insulated for the following reasons, which are addressed in further detail below:

  • Minimize heat gain
  • Maximize thermal comfort
  • Minimize energy loss, cooling load and operating cost for air conditioned buildings
  • Provide acoustic insulation
  • Prevent unwanted moisture condensation Ease of Application
  • Fiber glass wool being soft, resilient and non-sticky, can be unrolled easily over the purlins
  • Flanges are provided for easy stapling to make an uninterrupted layer of glass wool
  • High variety of roll lengths can be provided (from 7.5 m to 30 m) to match building design and to minimize number of joins
  • Can be easily cut and fold to accommodate openings through insulation
  • Don’t have any shot content which can be awkward during installation.